Mackie Digital 8Bus D8B v5.1 Instrukcja Użytkownika Pobierz pdf (Strona 116)

D8B Manual • Chapter 4 • page 110

Mixdown Setup

This simple checklist will help get the mix started.

Notice that, each time, we follow the signal path

from its source to its destination.

❏ Be sure the multitrack recorder is connected

properly to the Tape In card(s).

❏ Roll tape to verify signal at TAPE IN Fader Bank.

❏ If any track reads excessively hot or cold on the

D8B meter bridge, adjust the Digital Trim for a

reading around –15 with no peaks (OL).

Pressing DIGITAL TRIM activates the channel

V-Pots as digital input trim adjustments.

Digital clipping could occur if a signal going

into the D8B is too hot. Noise could occur if the

signal is too low. Even though the D8B has plenty

of headroom and very little noise, it’s still a good

idea to verify optimum levels.

❏ With channel faders off, set the Master Fader at

Unity.

❏ Select Master L/R in the Control Room section

and adjust the speaker level to a moderately con-

servative level (about 9:00).

2 TRACK A

DIGITAL IN 1

2 TR ACK B

DIGITAL IN 2

2 TRACK C

MASTER

L-R

NEAR FIELD

MAIN

CONTROL ROOM

SPEAKER LEVEL

MONO

SPEAKERS

❏ It’s often recommended that you monitor from

the output of the mixdown recorder.

If the outputs from the mixdown recorder are

patched into the D8B 2-track or Digital inputs,

simply select the mixdown recorder in the Control

Room Section (Digital 1, Digital 2, 2 Tracks A–C).

❏ Adjust the channel faders, dynamics, pan, effects,

and EQ for an excellent mix.

❏ Record the mix and enjoy the mind-boggling

capabilities of the Mackie Digital 8•Bus.

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 197 198

Komentarze do niniejszej Instrukcji

Brak uwag

Mackie Digital 8Bus D8B v5.1 Instrukcja Użytkownika Strona 116

Komentarze do niniejszej Instrukcji